Our super efficient solar heating
panels will raise your pool's temperature 10° or more using
the sun's free energy. When used in conjunction with a solar
blanket, it is all the heat you will need no expensive
heater to buy and maintain and no costly gas bills. The system
circulates pool water through the solar collectors where solar
energy is used to warm the water before it returns to the pool
whenever your pump is running.
|
|
|
Aboveground System
The Sunheater solar panels measure 2-feet by 20-feet and are made
from quality polypropylene. Each one comes with the following:
2 elbow/hose connector adapters, 2 end caps, connector hose for
additional collectors, 2 stainless steel clamps, 1 roll of Teflon
tape and a bilingual English/French installation/operation manual.
A diverter valve is available separately so the system can be
turned on and off independently of your pool's filtration system.
This is especially important if you run your filter during the
night, since you will want to turn off your solar heater then.
These systems are designed to be mounted on the ground, but a
Roof/Rack Mounting Kit is also available for installation on a
rack or nearby roof. For year-round swimming areas, add 1 collector
to the total listed in the order guide below.
| Order Guide For Aboveground
Pools |
| Round Pools To |
Oval Pools To |
Panels |
| 15' |
12' x 24' |
1 |
| 24' |
16' x 32' |
2 |
| 28' |
18' x 34' |
3 |
|
|
Inground System
The Sunheater inground solar heating panels are 4-feet by 20-feet
(Two 2x20 Panels) and made of quality polypropylene. Each panel
also comes with 5 stainless steel mounting brackets, 5 2-inch
#14 stainless steel screws, 2 rubber connector hoses, 4 stainless
steel clamps and a bilingual English/French installation/operation
manual. Each of the three Solar Heater Kits sold here also include
the System Kit, required for installation, which includes the
following: 1 1½-2-inch three-way diverter valve, 1 4-inch
hose, 2 pipe adapters, 1 end cap, 1 vacuum relief end cap, 5
stainless steel mounting brackets, 5 2-inch #14 stainless steel
screws, 100-foot web strap (which can cover up to 4 collectors),
1 spring check valve, 3 stainless steel clamps, 1 SxS Tee 1½-inch
and a bilingual English/French installation/operation manual.
| Order Guide For Inground
Pools |
| Pool Size Up To |
System Kit Size |
| 15' x 30' (15,000 gallons) |
2 Panel Kit |
| 16' x 36' (22,500 gallons) |
3 Panel Kit |
| 20' x 40' (30,000 gallons) |
4 Panel Kit |
|
|
|