POOLSTORE.com - Equipment / Alternative Sanitizers / Nature² Startup and Maintenance for Spas

Nature² Startup and Maintenance for Spas

Cartridge Startup

Step 1

Connect the support stems together and press onto main body to create a single device.

Step 2

Slide the entire device into the core of your existing spa filter cartridge. If your spa filter cartridge is:

	Open Top
	Simply slide unit in from the top. Position near the top half of the cartridge. (Support stems may be cut to position the cartridge correctly.)
	Open Top With Standpipe
	Some spa filter systems are configured with a standpipe running the length of the filter core. Simply slide unit in from the top. Position near the top half of the cartridge for easy retrieval.
	Closed Top
	Simply slide unit in from the bottom. Position unit to rest on shelf inside filter core.

Note: When installed, the Spa Purifier must be at least 1 inch above the bottom of the filter to prevent blocking water flow.

Spa Maintenance Recipe

Ingredients:

	Nature² Purifier
	Non-Chlorine oxidizer (potassium peroxymonosulfate)
	Test Kits (pH, Total Alkalinity)
	pH & Total Alkalinity adjusting chemicals
	Ozonator (optional)
	Sodium dichlor (chlorine granules) for Purifier Startup and occasional shock

After the 4 day or 14 day Cartridge Activation Period is completed, allow the chlorine level to drop to 0.4 - 0.6 ppm then:

How Often:	What to do:
Purifier Startup	Add 1 teaspoon of sodium dichlor to spa per 250 gallons.
Every Day	Run spa according to recommendation supplied to you by the manufacturer of your spa.
Before Each Use	Add 1 tablespoon of potassium peroxymonosulfate to spa per 250 gallons.
Once A Week	After using the spa, add 3 tablespoons of potassium peroxymonosulfate to spa per 250 gallons. Check and adjust pH and Total Alkalinity. If water does not stay clear for any reason, substitute 1 or 2 teaspoons of dichlor for the once-weekly shock of potassium peroxymonosulfate.
Every 4 Months	Drain and refill your spa. Replace Nature² Purifier and repeat Purifier startup.
As Needed	If water looks hazy, shock treat with 1 or 2 teaspoons of sodium dichlor per 250 gallons.